5l water bottle hose adapter
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This design allows to connect 6mm(inner diameter) hose to 5l or bigger water bottle.
- Rating
- 0 / 5
- Likes
- 8
- Downloads
- 58
- Makes
- 0
- Views
- 869
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Mechanical Parts
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This design allows to connect 6mm(inner diameter) hose to 5l or bigger water bottle.This adapter is air tight i used this in my compressor (2atm) to attach bottle as expansion tank.
To instal this adapter you need to drill 10mm hole in center of the cap.
You also need:
- four M4x20 screws with nuts and washers
silicon sealant (for best result use neutral one, not acid) or rubber seal I used silicon to make this air tight, you need to applay it beetwen each half and bottle cap, also it's good idea to add a little bit in screw holes.
You can choose between two designs, 28mm or 35mm outer diammeter. It depends on how big is you bottle cap.
To connect hose warm it a little bit.
Print Settings
Printer Brand:
Creality
Printer:
Ender 3
No
Supports:
No
0.2
Infill:
50
Filament:
fiberlogy PLA white
Notes:
4 parameeters
Category: DIY