5l water bottle hose adapter
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This design allows to connect 6mm(inner diameter) hose to 5l or bigger water bottle.
- Ocena
- 0 / 5
- Polubienia
- 8
- Pobrania
- 58
- Wydruki
- 0
- Wyświetlenia
- 869
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Mechanical Parts
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This design allows to connect 6mm(inner diameter) hose to 5l or bigger water bottle.This adapter is air tight i used this in my compressor (2atm) to attach bottle as expansion tank.
To instal this adapter you need to drill 10mm hole in center of the cap.
You also need:
- four M4x20 screws with nuts and washers
silicon sealant (for best result use neutral one, not acid) or rubber seal I used silicon to make this air tight, you need to applay it beetwen each half and bottle cap, also it's good idea to add a little bit in screw holes.
You can choose between two designs, 28mm or 35mm outer diammeter. It depends on how big is you bottle cap.
To connect hose warm it a little bit.
Print Settings
Printer Brand:
Creality
Printer:
Ender 3
No
Supports:
No
0.2
Infill:
50
Filament:
fiberlogy PLA white
Notes:
4 parameeters
Category: DIY