Case for Arduino Mega and 433 MHz transmitter and receiver
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Tucks away your Arduino Mega, 433 MHz transmitter, receiver with antennas including cables, and can be used with RFLink.
- Rating
- 5 / 5
- Likes
- 5
- Downloads
- 79
- Makes
- 1
- Views
- 631
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Share Alike
Can be used for an RFLink setup for example with an Arduino Mega (with micro USB or USB-C connector), a 433 MHz superheterodyne transmitter, and a receiver with copper antennas. The case is a somewhat loose friction fit, to make it easy to print and take apart in case you need to do any maintenance. There are slots for the antennas in the top, to get the largest range possible. There is also a cutout in the back of the bottom part, that should fit most micro USB and USB-C cables.
Prints nicely in PLA in the default model orientation without supports at a layer height of 0.20 mm.
If you like what I'm doing, please give it a like 👍 consider joining my club or buying me a coffee! 😃👍
Necessary materials
- 2x Threaded insert M3x3.0mm (note: must be the short ones, the regular M3 are too long!)
- 2x M3x6 screw
- 1x Arduino Mega with a Micro USB or USB-C port
- 1x 433 MHz superheterodyne transmitter and receiver with copper antennas
- Dupont wires (amount depends on your transmitter and receiver)
Instructions
- Print both the top and the bottom part once each
- Install the threaded insert in the holes of the bottom part
- Place the Arduino Mega into the bottom part
- Screw in the M3 screws into the threaded inserts through the Arduino Mega
- Connect the transmitter and receiver to the Arduino Mega using the Dupont wires
- Stick the copper antennas through the openings of the top part and slide them forward, they should hold on to their own
- Close the case by putting the top part onto the bottom part
