Suppressor/Silencer Mount
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Universal low-profile mounts for mounting your suppressors/silencers to walls, safe doors, etc...
- Rating
- 0 / 5
- Likes
- 23
- Downloads
- 227
- Makes
- 0
- Views
- 1,031
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Gadgets
- License
- Creative Commons — Attribution — Noncommercial
NOTE: The revised version fixes a few minor errors and adds additional vertical support.
These were designed to allow you to mount multiple suppressors of varying calibers to different surfaces including walls, safe doors, etc… These models have two mounting options, either velcro or an M3 screw. The recess in the back was designed for 1" 3M Dual Lock Low Profile Velcro but other 1" velcro can be used. The recess allows one side of the velcro to be recessed in the model so that the model lays flush against your mounting surface when the male and female parts are connected. These were also designed to be as slim as possible allowing for storage in compact spaces. To use simply print, install, and then slide your suppressor over the dowel with the end cap facing downwards. These should not cause any damage to the internals of your suppressor although the mount itself could begin to show signs of wear after heavy use.
Note: If you are going to be using velcro I would recommend printing the tall version as it will give the velcro twice the amount of surface area for better adhesion.
Also, the 30cal is compatible with any 9mm suppressor or firearm.
These could also be used as a universal mount for pistols although due to the increased weight and varying barrel lengths, I cannot ensure they will work with all models or that they will be strong enough to adhere to your desired surface using only the velcro. Feedback is greatly appreciated.
Print Settings:
PLA+ Preferred
3 Walls
15%+ Gyroid Infill
Support is not needed but may be helpful to ensure a perfectly round screw hole, otherwise, you may need to use a small drill bit in reverse to round out the hole if you have any fitment issues. (If using support normal vs. tree is preferred)
Link to velcro I used:
(https://www.amazon.com/3M-Dual-Lock-Reclosable-Fastener/dp/B004V3RALO/ref=sr_1_3?hvadid=580936827991&hvdev=c&hvlocphy=9028304&hvnetw=g&hvqmt=e&hvrand=8591617834849022783&hvtargid=kwd-1086641473&hydadcr=981_1014986899&keywords=3m+dual+lock+low+profile&qid=1697046793&sr=8-3)