Galaxy Watch Charging Stand (medium height remix)
We calculate the final price from your selected file. You review and accept it before payment.
Preliminary estimate for PETG
€3.05 – €3.72 net (excluding VAT)
For file: watch6stand_0.15mm_PETG_MK3S_3h57m.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €3.39 excluding VAT (range midpoint).
- Weight reported by the author
- 33 g
- Print time reported by the author
- 3.94 hr
- Source material
- PET
- Estimate material
- PETG
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
Avise's Galaxy Watch Charging Stand remixed for medium height, wider base, and tighter cord grip.
- Rating
- 5 / 5
- Likes
- 11
- Downloads
- 82
- Makes
- 1
- Views
- 400
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Other Gadgets
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a remix of Avise's Galaxy Watch5 Charging Stand With Removal Hole to medium height, with a longer base, and tighter cord grip. The height is in between the original and the tall model, with the highest point being 120mm.
Differences of the remix compared to the original
- Modified the height to be between the original and the original-tall versions.
- Made the cord channel 1mm deeper and added a lip to hold the cord tighter
- Extended the base by 6mm forward and back to add some stability.
- Included right and left hand cord versions
I am using it with a Galaxy Watch 6 44mm, but it will fit any that Avise's original 30mm charging puck models fit. (I have not made a 33mm puck version.)
Right and Left side cord
I noticed that someone had remixed the original to put the cord on the right, so I am including a right hand version of my remix as well.
Base infill
In addition to the longer base, I was planning to selectively print the base with 100% infill, but have found that my default 15% infill is not as unstable as it feels due to the light weight. The attached petg gcode is using 15% throughout.