LED Cob Strip Clips for Caldwell Ballistic Chronograph
We calculate the final price from your selected file. You review and accept it before payment.
Preliminary estimate for PETG
€0.08 – €0.10 net (excluding VAT)
For file: chrono_light_clip_0.4n_0.3mm_PETG_MK4_6m.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €0.09 excluding VAT (range midpoint).
- Weight reported by the author
- 1 g
- Print time reported by the author
- 6 min
- Source material
- PET
- Estimate material
- PETG
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
Clips to hold LED cob strips on top of the sun shades of a Caldwell ballistic chronograph
- Rating
- 0 / 5
- Likes
- 4
- Downloads
- 26
- Makes
- 0
- Views
- 409
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor Sports
- License
- Creative Commons — Attribution — Noncommercial
I made these clips to hold some cheap LED cob strips on top of the sun shades for low light use. I first tried with some RGB strips that I had, but the LEDs were spaced too far a part and produced mostly errors.
Printed in PETG using spiral vase mode at 0.3mm layer height, and with no bottom layers. I also included gcode that was sliced at 0.2mm in case of layer adhesion issues.
The LED strip I used is 2mm thick and 8mm wide. Here is a (non-affiliate) link to the exact one I used: https://www.amazon.ca/gp/aw/d/B0C2P8CZBD?psc=1&ref=ppx_pop_mob_b_asin_title