Biqu H2 V2S Lite - Voron Mount
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Mount for the Biqu H2 V2S Lite - Extruder on the old (CW1-compatible) Voron X-Carriage-Frame
- Rating
- 0 / 5
- Likes
- 19
- Downloads
- 132
- Makes
- 0
- Views
- 1,345
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Voron Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
A mounting bracket to put a Biqu H2 V2S Lite on a Voron X-Carriage-Frame.
Only compatible with the old (CW1) X-Frame, since the screws go in from the rear.
The extruder is 2mm offset from the x-carriage, so that it clears the right xy-joint.
But since this toolhead is wider than an Afterburner or Stealthburner you, will loose either x-travel or y-travel on the front right corner, because it will not clear the right front idler.
Materials required:
2x M3x5x4mm Heat Set Inserts (Voron-spec)
2x M3x20 SHCS (upper x-carriage screws, from the rear)
1x M3x12-16 SHCS or BHCS (lower right mount-screw)
1x M3x8 SHCS or BHCS (lower left mount-screw)
2x M3x14 SHCS or BHCS (upper extruder-screws)
2x M3x10 SHCS or BHCS (lower extruder-screws)