1 / 2
Ceiling or Wall mount for RC planes
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Single screw ceiling mount for RC planes.
- Rating
- 0 / 5
- Likes
- 4
- Downloads
- 42
- Makes
- 0
- Views
- 636
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- RC & Robotics
- License
- Creative Commons — Attribution — Noncommercial
Low wing can mount inverted while high-wing can mount rightside up.
The rods are mounted at an approximately 15deg angle meaning the plane will be pressed against the surface as it is inserted, providing a secure hold with friction alone.
Print as a single piece with no supports.
A single 10x1000mm (3/8x36in) rod (aluminum, wood, carbon, etc) can be cut in half and inserted into the holes. Trim length as desired.
A 10x65 (3/8x2.5in)mm lag screw is used to secure it to a stud. Smaller screws with washers can also be used.