1 / 5
Sony PVM-14L5 Deflection Board Mounting Bracket
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A replacement for the fragile factory bracket.
- Rating
- 0 / 5
- Likes
- 5
- Downloads
- 47
- Makes
- 0
- Views
- 439
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Mechanical Parts
- License
- Creative Commons — Attribution — Share Alike
Description:
A replacement for the Sony PVM-14L5 fragile factory D board mounting bracket.
FDM_0165 is a remix significantly changes the geometry for better durability and printability. This is a two piece print and requires adhesion post processing.
FDM_0186 is a brand new clean sheet design which is designed to be significantly stronger, easier to print, and prints in one piece. It requires a slightly larger bed size, it will fit on a Bambu X1C / P1S.
Purchase:
- Also available to purchase on kytor.com/store
Printing:
- Use FlashForge ASA or equivalent alternate ASA: amzn.to/3szLrtP
- 0.4mm Nozzle, 0.2mm height, 50%+ infill, 4 walls, brim, snug supports
- Do not use PLA
FDM_0165 (Two Piece) Assembly:
- Always use proper PPE when handling Acetone.
- Use a Q-Tip or brush to thoroughly coat both mating surfaces in Acetone, repeat brush on of Acetone 3-4 times for best results, then clamp together in six places as shown in the photo for 30-60 minutes.
- Allow a minimum of 24-48 hours to cure before installation.
History:
- FDM_0165 - Remix of staffanu's D-Board bracket
- Rev 0 - Initial public release
- Rev 1 - Geometry updates for reduced corner lifting probability
- FDM_0186 - Next gen clean sheet design
- Rev0 - Initial public release
Note: Amazon links are affiliates.