Carry Handle for Lasko S18924 18" Pedestal Fan
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
It's a carry handle for your fan.
- Rating
- 0 / 5
- Likes
- 5
- Downloads
- 24
- Makes
- 0
- Views
- 204
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other House Equipment
- License
- Creative Commons — Attribution — Noncommercial
My family has a Lasko S18924 pedestal fan that we got from Walmart ages ago. A constant lamentation each time one of us has to move the fan somewhere is that it doesn't have an easy to way to carry it!
Enter this carry handle, which attaches to the fan's motor housing. To install, you will need to remove the housing from the motor, slide the handle onto the housing, then screw the housing back onto the fan.
A one-piece design that prints without supports and installs without fasteners or adhesives.
I designed this by tracing the housing with a pen onto a paper, scanning that as a PDF, then importing that tracing as a vector into Fusion360. Things might not be perfectly symmetrical as a result.
I printed mine in PETG:
- 0.15mm layers (for maximum layer adhesion)
- 6 perimeters with a 0.4mm nozzle for over-built strength. It is load-bearing, after all.
- 30% gyroid infill
Alternative print settings to save time (0.4mm nozzle). It's probably good enough:
- PETG or ABS (ABS elephant's foot may make it hard to install!)
- 0.30mm layers
- 4 perimeters
- 15% gyroid infill
If you have a 0.6mm nozzle:
- 0.4mm layers
- 3 perimeters (0.72mm extrusion width)
- 15% gyroid infill
STEP file included!
