Intex sand filter waste port adapter
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Intex sand pump 6-way valve waste port to 1.25" pool hose
- Rating
- 5 / 5
- Likes
- 159
- Downloads
- 882
- Makes
- 12
- Views
- 5,736
- Reviews
- 10
Updated at source:
Model information
- Source
- Printables
- Category
- Summer
- License
- Creative Commons — Attribution — Noncommercial
I couldn't find a model here or any other site I checked that would screw on the waste port on our Intex sand filter. After some hair-pulling (Intex seems to use an oddball thread) in Fusion and several iterations, I now have an adapter. I can use the 1.25" pool hose from the vacuum to route the discharge water (draining, backflushing, etc) away from the pool area to a more convenient area.
The thread OD is 60mm, 10TPI, angle (best I can tell) is 60deg, thread ID is about 57.5mm.
Recommend PETG since this is an outdoor use item. Supports not needed if printed as shown in the pic. I chose that orientation to get a smooth surface for the rubber seal on the port. Used a brim just in case, but that depends on your bed adhesion strength.