1 / 8
Bosch FlexiClick FC Holder 12V for Ikea Skadis, GSR 12V-15 FC, GSR 12V-35 FC — image 1
1 / 8

Bosch FlexiClick FC Holder 12V for Ikea Skadis, GSR 12V-15 FC, GSR 12V-35 FC

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

A holder for Bosch FlexiClick (FC) 12V attachments for IKEA SKÅDIS pegboards. For Bosch GFA 12-B, 12-W, 12-E, 12-X, 12-H

Rating
5 / 5
Likes
70
Downloads
283
Makes
2
Views
1,634
Reviews
2

Updated at source:

Model information

Category
Tools
License
Creative Commons — Attribution — Noncommercial

This is a holder for Bosch 12V FlexiClick Attachments (GFA) for IKEA SKÅDIS pegboards. It's compatible with attachments for Bosch GSR 12V-15 FC and GSR 12V-35 FC. It uses Skadis T-Nuts for secure, rattle-free attachment to the pegboard.

This holder is a remix of the FlexiClick belt holder by Max4711. I recreated it as a two-part model that can be printed without supports or sagging layers. STEP files are available too.

Note: This is not compatible with 18V FlexiClick attachments.

Read more about the Skadis T-Nuts Mounting System and check out the Skadis T-Nuts Collection for more Skadis accessories that use T-Nuts.

 

Required Hardware

QtyDescriptionSourcing
4M2.5x12mm Socket Head Cap ScrewAliexpress
4M2.5 DIN934 Hex NutAliexpress

 

Printed Parts

QtyPartDownload
1Skadis FlexiClick 12V Holder Frame.stlthis project
1Skadis FlexiClick 12V Holder Shaft Guide.stlthis project
4Skadis T-Nut M2.5.stlDownload here

 

Printing

Print the parts in the original orientation. All STLs are pre-rotated for printing.

  • Material: PETG or other rigid material with decent layer adhesion
  • Layer height: 0.2mm
  • Extrusion width: 0.4mm or 0.45mm
  • Perimeters: 4
  • Infill: 15%
  • Supports: No

 

Assembly & Installation

Step 1: Prepare T-Nuts

Insert the hex nuts into the bottom of the T-Nuts. The nuts should fit tightly and not fall out. Use superglue if the fit is loose and be careful to not get any glue onto the threads.

Step 2: Assemble Holder

Insert the Shaft Guide into the Frame from the bottom and make sure the indentations line up. It's recommended to permanently glue these parts together with a few dots of superglue so you don't have to hold it in place when installing it on the board. Though, it works without superglue too.

Step 3: Add T-Nuts

Push the four M2.5 screws into the screw holes all the way and screw on the T-Nuts until there's a gap of about 2mm between the T-Nut and the Holder

Step 4: Installation

Orient the T-Nuts vertically and then push the whole assembly through the holes in the desired location on your pegboard. While maintaining some pressure on the screwdriver, tighten all 4 screws but do not over-tighten. As you tighten, the T-Nuts will lock in the horizontal orientation.

Ready to use

Your FlexiClick attachments attach to the holder the same way as they attach to the drill, with a satisfying click.

 

Tags