Band-Aid/ bandage container Version 2
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
V2 of a container to hold bandages (V3 coming soon (TM)).
- Rating
- 5 / 5
- Likes
- 50
- Downloads
- 292
- Makes
- 2
- Views
- 1,460
- Reviews
- 2
Updated at source:
Model information
- Source
- Printables
- Category
- Home Medical Tools
- License
- Creative Commons — Attribution — Share Alike
12/17/2023: Band-Aid/ bandage container V2
This is version 2 (V2) of a container to store bandaids. This specific one holds about 17 bandaids in each slot before it starts to get a bit tight, but you can increase the height of the model to extend that capacity.
The lid is currently held in place with a block that fits into the similarly sized hole (located front left [when looking at the model from the front]) {see video below}, but that method of lid retention will change in a future version (more on the future version later).
Print settings I used for this:
- Prusament PLA Natural White
- 20% Cubic infill
- This model was also printed with supports (these were moderately difficult to remove)
- All other settings were the defaults in the Prusa Slicer profile for the 0.2mm mk4 Speed
Future version plan (coming soon TM):
V3 - will change the lid mounting so it can stay on when the container is inverted and a divot in the slanting portions to slide your finger underneath the bandaid.
---------------------------------------------------------------------------------------------------------
12/3/2023: Band-Aid/ bandage container V1
This is version 1 (V1) of a container to store bandaids. This specific one holds about 17 bandaids in each slot before it starts to get a bit tight, but you can increase the height of the model to extend that capacity.
The lid is currently held in place with a block that fits into the similarly sized hole (located front left [when looking at the model from the front]) {see video below}, but that method of lid retention will change in a future version (more on this and future versions later).
Print settings I used for this:
- Prusament PLA Galaxy Silver
- 20% Cubic infill
- This model was also printed with supports (these were moderately difficult to remove)
- All other settings were the defaults in the Prusa Slicer profile for the 0.2mm mk4 Speed
Future version plans (coming soon TM):
V2 - will add raised sections to the bottom for easier grabbing of Band-Aids (especially when running low)
V3 - will change the lid mounting so it can stay on when the container is inverted