Creality K1 Risers Hexagon Accents
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A remix of a few models for the Creality K1 Riser so its printable on a 235mm bed.
- Rating
- 0 / 5
- Likes
- 41
- Downloads
- 221
- Makes
- 0
- Views
- 1,886
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Creality Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Out of the four corner pieces, the back left and back right are different due to the special back wall for the bowden tube and the toolhead wire.
Everything was printed in PLA with slim three supports. Print the models as is with brim to prevent warping since they are long pieces.
Printing Parameters:
- Material: PLA
- Temp: 235C
- Brim: ON
- Support: ON, Slim Tree
Additional Material:
- M3x10mm - 4 ea - To screw the corner pieces into the frame
To install the corner pieces, remove the original four screws that the K1 lid clips into. Screw those screws into the top hole of each of the corner pieces. Then screw in your M3x10mm screws into the bottom hole and then into the frame of the machine.
You can increase or decrease the size of the sliding vent by 1 or 2% to make it slide smoother or tighter depending on your preference and printer tolerance.
Let me know if you guys want me to make different sides with different slot types. I will be updating this with new side designs.
Happy Printing!
Update: I designed some add-on LED light slots to add more lights to the chambers! Models can be found here.