Quick swap lightweight magnetic power bank 5000mAh mount for Quest 2 with Rift CV1 strap
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Lightweight, hot swap portable power solution for Quest 2 with Rfit CV1 head strap
- Rating
- 0 / 5
- Likes
- 4
- Downloads
- 21
- Makes
- 0
- Views
- 642
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Video Games
- License
- Creative Commons — Attribution — Noncommercial
For a while wanted to have very light power bank mount for my Quest 2/Rift CV1 strap with option to quick swap batteries when needed without even taking off the headset.
Decided to use extremely power dense but very light Nitecore 5000mAh battery with included magnetic power bank attachment. The weight of the total set of printed part plus battery is only 106 grams! and without the attached battery its only a small fraction of that. The output power of the power bank is 1.38A which is similar to my other power banks I used.
For this to work you will need:
- 1 x Nitecore MBP21 intelligent battery system kit
- 2 printed parts. See pictures for printing orientation suggestion as you will need to inset magnets.
- 3 x 20mm x 6mm x 1.5mm magnets
- 3 x M3 x 6mm countersunk/flat screws
- 3 x 3mm inserts ( and probably something to install them - soldering iron works great)
- I also provided small printed template for easy drilling into head strap but that is option.
Nitecore MBP21 set with NL2150HPI battery.

Battery with magnetic power bank attached.

Printed parts:


Installation instruction: Make sure you install first 3mm insert. Power bank attachment has two cutouts. One for charging cable so you can even charge back the battery using this attachment and also one inspection hole to see status/charging diodes.


I recommend using 30cm angeled (on both sides) usb C to usbA cable.

Weight check

Remember to print on the side to inset the magnets! The magnets of the power bank attachment alone are not enough to hold the battery. Once installed properly you will be able to achieve that sweet sweet tacticool snap-on effect.

Two additional inserts for installation on the headstrap.

Use the below template for easy drilling. Print it with the brim! To install the screws on the other side you will need to carefully peel the glued on felt from the inside and install screws under so they can be then covered by the fabric.

The effect:


If you found it useful you can Buy me a Coffee!