1 / 2
Onewheel Pint/XR Extended Stand
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Onewheel vertical stand with extended depth for use with aftermarket, angled rails. Will fit Pint/XR TFL WTF rails.
- Rating
- 5 / 5
- Likes
- 28
- Downloads
- 335
- Makes
- 1
- Views
- 1,216
- Reviews
- 2
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
OneWheel vertical stand with extended depth for use with aftermarket, angled rails. Tested and will fit Pint or XR with TFL WTF rails. While theoretically it may work with stock straight rails, it'd lean much farther back than it would on the original model.
Printing Instructions
Print in your preferred material with as much infill as you like, but here are some print settings recommendations:
- 10% or higher infill should be plenty strong.
- Supports disabled!
Once configured:
- Print the model on its side, with no supports.
- Take it off your print bed when it's done. Boom.