1 / 2
Finger Racers
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Estimated printing price per file
€0.44 – €0.53 net (excluding VAT)
For file: finger-racer_0.4n_0.2mm_PLA_MINIIS_29m.bgcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €0.49 excluding VAT (range midpoint).
- Weight reported by the author
- 6 g
- Print time reported by the author
- 29.4 min
- Source material
- PLA
- Estimate material
- PLA
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
Racing toy for fingers.
- Rating
- 5 / 5
- Likes
- 103
- Downloads
- 260
- Makes
- 1
- Views
- 1,256
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Vehicles
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a little racing toy for fingertips:
- The model is oriented for easy printing. No supports should be needed. Plain bearing is print-in-place.
- The “pedals” are printed as one piece but breaks apart for press-fitting into the wheel hub. Clean up with a side-cutter if needed. The press-fit can be a bit tight, carefully use pliers if finger strength is not enough.
- The wheel needs a “tire” for more friction. I cut loops from an old bicycle inner tube. An easy alternative is to just wrap around with some duct tape or electrical tape, or use a broad rubber band.
- It can be used without the tire but then works best where it is not too slippery, like carpets, vinyl or painted surfaces.