Base and Display Holder for ESP-32 E-Paper Weather Display
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Base and Screen Holder for ESP-32 E-Paper weather display created by Luke Marzen (lmarzen on github).
- Rating
- 4 / 5
- Likes
- 44
- Downloads
- 248
- Makes
- 1
- Views
- 6,516
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Share Alike
Case to hold a completed build of Luke Marzen's ESP32 E-Paper Weather Display found on github here: https://github.com/lmarzen/esp32-weather-epd/
If you follow lmarzen's instructions on github you'll need this case to hold:
- a 7.5" E Ink Display, Controller and adapter
- FireBeetle 2 ESP32-E Microcontroller
- BME280 - Pressure, Temperature, and Humidity Sensor
- 5000mah Lipo Battery (I used this one : https://a.co/d/g1CG0nQ)
This case is specifically designed with the mounting points to hold the Waveshare 7.5" 800x480px e-Paper display that is available here: https://www.waveshare.com/product/7.5inch-e-paper.htm
In addition to the parts specifically laid out in the github build you'll need the following:
- 8 @ 3mm heat set inserts
- 2 @ 2.5mm scres (the ones that come with the Waveshare display worked perfectly for me)
Future Changes to be made:
- O/A mounting height of ESP32 is a bit high, if it was 5mm closer to the top of the case there'd be better clearance for the DuPont connectors.
- Fix clearances on bottom cover to make cover slide in more thightly
- add a bit more material below the USB-C port
- Redesign battery holder to make a more solid attachment
- Add a fixed attachment point for the BME280 near a grille to allow outside air to determine the values it receives rather than those in the case
- figure out mounting for a reset button
- figure out if ESP 32 can be mounted further toward the center of the case to allow more clearance for the battery connector.
- General tidying