1 / 3
MK3s+ extruder motor cooling duct remix v1 — image 1
1 / 3

MK3s+ extruder motor cooling duct remix v1

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Remix Extruder stepper motor cooling duct for MK3S+

Rating
4.5 / 5
Likes
36
Downloads
224
Makes
3
Views
2,617
Reviews
2

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial — Share Alike

Disclaimer: This is a remix, original designs belongs to creator. Original model: https://www.thingiverse.com/thing:2975582

Design improved for better motor fitting and cable management.

Designed for 40 x 40 x 12mm 5V fan manofactured by Noctua https://noctua.at/es/products/fan/nf-a4x10-5v

Purchase link: https://www.amazon.es/Noctua-NF-A4X10-FLX-5V-ordenador-Ventilador/dp/B00NEMGCIA

Direct fitting with original hardware replaces IR filament sensor top cover and snaps on around the motor.

There is a canal to fit the cable between the part and the motor reaching original routing. It's possible to route a new cable to the electronics box or solder in parallel to orginal hotend fan.

DO NOT CONNECT THE YELLOW WIRE!!! IT'S RMP SIGNAL, DO NOT CONECT WITH OTHER YELLOW CABLE OF ORIGINAL FAN!!!

Fan snaps on directly (no glue or screws needed) an can pass trough the part without detaching the cable.

Also added STEP file for anyone to make changes and keep improving.

Updated M6 thread for reverse bowden setup and thread test stl file.

Tags