1 / 1
Improved/modified/additional N90 parts
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Some parts to improve your experience with the N90
- Rating
- 1 / 5
- Likes
- 34
- Downloads
- 125
- Makes
- 0
- Views
- 1,401
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Other Toys & Games
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
1pcBP:
- removes the option for a magnetic buttplate
- uses M5x10mm nuts and screws to attach to the rear instead
barrel:
- to attach the muzzle! not included in the original fileset, but it is designed for this other muzzle…
- mine friction fit with the help of a mallet, mileage may vary
muzzle:
- modified to fit the other way round
- slightly resembles an actual P90 muzzle
nut holder:
- reinforced, thicker walls, can take a little more force than the original
- more tight fitting into the left and right halves of the blaster
- May require light filing to press-fit
nightingale cage:
- designed for worker nightingale motors and flywheels
- requires an M4x40mm nut and screw instead of the M5
Personal print settings:
PETG, 4 walls, 20% cubic infill (100% for the nut holder), 0.2 layer height
only nightingale cage needs support
Personal N90 hardware list:
this is what I used for my build, hope this helps for yours!
front section:
- m5x25 nut and screw - 4pcs (outer and roller assembly)
- m4x40 nut and screw - 1pcs (nightingale cage)
- m5x30 nut and screw - 1pcs (top cover hinge)
- m5x10 nut and screw - 2pcs (N20 motor retention and magwell)
- m3x10 nut and screw - 1pcs (pinwheel retention, m3x12 screw may be needed if 10mm is too short)
- motor screws - 4pcs
- m5x30 metal dowel pins - 6pcs (guide roller pins)
- m5.2xD8xL10 metal bushings - 7pcs (replaces the printed guide rollers)
- 5mmx3mm cylinder-style magnets - 16pcs (12pcs for top cover, 4pcs for “screw cover left” and “screw cover right”)
rear section:
- m5x25 nut and screw - 2pcs (mag release and body to stock lower)
- m5x30 nut and screw - 1pcs (body to stock upper)
- m5x10 nut and screw - 2pcs (buttplate attach)
- springs - 2pcs (mag release and mag ejector, mag ejector spring recommended but optional)
electronics:
- worker nightingale motors and flywheels - 1pair (2 motors and 2 flywheels)
- N20 motor (500rpm) - 1pcs (pinwheel)
- Omron lever microswitch - 2pcs
- (https://outofdarts.com/products/21a-microswitch-genuine-omron-v-212-1c6-spdt)
- one more switch can be wired at the pinwheel, but idk how to do that. if you do, that's a total of 3 microswitches
- XT60 female connector - 1pcs
- wire (idk man however much you need)
wiring is similar to uhhh… a rapidstrike/flycore/cagefighter/auto-stryfe
Good luck building!