1 / 4
Remix Laptop stand with connecting rods
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A remix to "BurgessG's" laptop stand to include some connecting rods, my laptop is on and off lots and wanted stability
- Rating
- 0 / 5
- Likes
- 13
- Downloads
- 156
- Makes
- 0
- Views
- 551
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Computers
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Just a couple simple connector rods, was going to glue them in but they were snug enough of a fit I didn't bother. tried to make them blend in with the regular model and not botch it up too much. Hope it saved you a few minutes.
Version 2 includes minor changes to solve the issue of connector rods not fitting if using a different infill percentage. Print without bottom and top layer and Hex infill if you wish to have the same open look.