1 / 4
Bresser Station Gateway Board - a simple arduino Lora gateway for Bresser weather station — image 1
1 / 4

Bresser Station Gateway Board - a simple arduino Lora gateway for Bresser weather station

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Simple case for Klinkon Electronics BSG board, in order to enclose the PCB and protect the electronics

Rating
5 / 5
Likes
3
Downloads
20
Makes
2
Views
585
Reviews
1

Updated at source:

Model information

Category
Electronics
License
Creative Commons — Attribution — Share Alike

Klinkon Electronics has been collaborating for many years on many projects with DeLucaLabs, a maker's laboratory near Sedico (BL).

Together with them we are developing a system to connect as many stations as possible to our AMMS environmental monitoring service (Autonomous Meteorological Monitoring System, a monitoring system with several interconnected weather stations for the purpose of acquiring data on environmental conditions and processing simple weather forecasts, creating an OpenData archive with the data collected), and in order to reduce costs and technical difficulties, we also researched weather stations that could be easily modified, with a focus on cheap ones from Amazon, mainly the Bresser 5-in-1 and 7-in-1, and integrating them with an IOT Gateway, taking our cue from the OpenSource BresserWeatherSensorReceiver project by Matthias Prinke, consisting of an RFM95W-915S2 radio module and driven by an ESP32 that will analyse the data received from the weather station and then send it via the Internet to our centralised system.

Thus was born the BSG Board, a small board (of which you can find schematics and firmware in this article) that takes care of reading data and sending it to our system, and can also be used as a Lora to Esp32 gateway.

Obviously, we cannot leave our board without a case, so our contributor Alberto Da Rold has designed a simple case for the board, which we upload here in both the thin and the slightly thicker version (the only difference is how intense the LED brightness is, in the thin version it will be more visible, in the thick version it is dimmer).
The board fits between the two pieces, while the cover needs four hot brass m2.5 inserts for the screws. The board's i2c port is also accessible for external expansion.

 

 

 

 

Tags