Boruit V10 Case With Clip and Magnet Support
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A design with inspiration from Hudson Bear, and Charely6s designs, which adds options for attachments/accesories :)
- Rating
- 4 / 5
- Likes
- 9
- Downloads
- 86
- Makes
- 1
- Views
- 366
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Other Gadgets
- License
- Creative Commons — Attribution — Noncommercial
A remix that combines Hudson Bear, and Charely6s designs, and adds multiple magnet options :)
There is options for 10x1.5, 8x3, and no magnets in the bottom. In my opinion, the magnets are not necessary, as the tolerances are tight enough for the flashlight to friction fit into the case, but still easy to pull out.
I'm also working on an accessory feature in V2.0, which allows you to print the clip on its side so it doesn't snap as easy, and lots of other accessories. However I haven't found the courage to finish the feature, so it may change in the future. There is also only a single accessory ATM, even though there is infinite potential - so very much work in progress. Therefore I can obviously not update the pictures ATM either.
However since someone could use my half finished designs while I finished them up, I'm posting them as a V1.5.
I sliced using 3 walls, with 30% cubic infill, using PETG.
-----------------------------------l
Disclaimer - I marked the model as an original, because there was not any licenses available if I labelled it as a remix.