1 / 3
APRS Weather Station
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
APRS WX station
- Rating
- 0 / 5
- Likes
- 63
- Downloads
- 134
- Makes
- 1
- Views
- 2,261
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Share Alike
Features
- Measures values
- Temperature (inside not exactly), external in sunshield
- Relative humidity
- Dew point calculated
- Pressure
- Wind speed - with three blades
- Wind direction
- Rain with a resolution of 0.14 mm
- Ethernet RJ45 connection
- Powered via passive POE with own adapter
- Single mounting point installation with simple mounting with two plastic binding tapes
- Design supports an easy change of the diameter mounting tube, by replacing one 3D printed part (number 2).
- Simply replace the vanes of the anemometer (if they are damaged) without disassembly
- Simply replace the paddle of wind direction (if they are damaged) without disassembly
- No wiring, just fit two PCBs
- Completely 3D printed
- Publish data to MQTT
- Stores the maximum historically measured wind speed value with a time stamp to the eeprom
- Direct sending data to aprs.fi (if you have a radio amateur license)
- Setup via IP Telnet, with security using a hundred character security key
- Display of raw values of all internal sensors
- USB-C connector for read security key
- OTA update via web interface
- Web MQTT wall, for simple debugging
- Hardware expandable by (they are not implemented in firmware)
- RFM96W-433S2 LoRa module (PCB antenna designed on main board), or other pin compatible module
- SHT30 sensor
- MS563702BA03 sensor
- ICP-10111 sensor
- Optional external SD18B20 thermistor with Double sun shield for thermometer - also 3D printed
- Automatic detection of connection of external thermometer DS18B20 and switch to its values
- Optional WiFi e-ink display