1 / 2
Lehre für PINDA/SPINDA (variable layer height, faster print)
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Identical to original, but I'm providing a 3MF file with variable layer heights which reduces print time a lot.
- Rating
- 0 / 5
- Likes
- 7
- Downloads
- 103
- Makes
- 0
- Views
- 705
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
To have all top surfaces of the model be at their intended height, you must either use 0.1mm layers everywhere (except 1st layer), or you can use 0.3mm layers with thin layers only where needed to get the correct top layer heights. Using 0.1mm layers has a print time of around an hour, using 0.3mm layers with a few thin layers has a print time of less than 30 minutes.
I'm only adding this as a remix because PrusaPrinters does not allow uploading .3mf files as user print files.