Bottle Cap Bin for Klarstein 201L Beer Fridge
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A bin to catch falling bottle caps from a bottle opener attached to the door of a Klarstein Beer Fridge.
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 25
- Makes
- 0
- Views
- 211
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Kitchen
- License
- Creative Commons — Attribution
This model is for affixing a bottle cap bin to the top of the door handle on a Klarstein 201L Beer Fridge. Holes for the bottle opener were drilled and tapped, and the opener installed seperately. This model is only for the cap bin.
The magnets used are these 20mm x 10mm x 2 mm ones, ordered from Amazon. Friction fit, no need for glue.
Note: the magnets I was sent are actually 3mm magnets, not 2mm. Using a calipers, the magnets I was shipped measure 19.65mm x 9.6mm x 2.85mm. The holes in the model are sized for the thicker 3mm magnet (2.85mm). If you order these and actually get 2mm magnets, put a thin piece of paper in the hole first to keep the magnet from sinking too deep.
The screw used is 32mm x 4.2mm, from this set. Dimensions of the screw are in the pictures so you can find something similar.
The model was printed upright, with paint on support enforcers just on the underside cut out (see screenshot). “XY separation between model and support” was set to 2mm. Do not leave this setting on its default value, or you'll have serious issues getting the support out of the magnet holes on the cap bin model. No support needed on the base that attaches to the door handle.