1 / 3
Pan & Tilt 1/4-20 Webcam Monitor Mount — image 1
1 / 3

Pan & Tilt 1/4-20 Webcam Monitor Mount

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

A *simple* top monitor mount for your 1/4-20 bolt webcam that allows side-to-side pan and up-down tilt.

Rating
0 / 5
Likes
24
Downloads
255
Makes
0
Views
1,661
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution

Most monitor mounted webcams only allow tilting up and down.  I have two monitors side-by-side, and the ideal camera angle requires the camera to pan to one side for a more direct angle.  I wanted a solution that was simple and ultra-minimalist. 

This mount supports any webcam that has 1/4-20 threads (usually for a tripod) on the bottom. I have a Logitech C920, an Anker PowerConf C200, and an AnkerWork C310, all of which have the same tripod screw on the bottom. 

While the pan/tilt angles can be adjusted to suit almost any need, the ball & socket are a pretty tight fit - so this is not the model for you if you are constantly wanting to adjust camera angles. 

The photos are with the mount and ballnut in galaxy black Prusament PETG, and the bolt in black Hatchbox PETG. 

Printing Instructions

Orientations as shown here:

  • mount.stl: 
    • PETG
    • 50% gyroid infill
    • 0.4 nozzle and 0.20mm layer height
    • Brim enabled
  • mount-long.stl (optional):
    • See mount.stl
    • The bezels and rear housing on monitors are all different shapes and sizes. Modify this object in your slicer with a negative volume box to cut down the legs to whatever length is ideal for your particular monitor.
  • ballnut.stl:
    • PETG
    • 50% gyroid infill
    • 0.4 nozzle and 0.10mm layer height
    • Brim enabled
  • double-ended-bolt.stl:
    • WARNING: Plastic printed screws & bolts will break.  Please don't print a weak bolt with the wrong material and slicer settings and break it off inside your camera.
    • PETG
    • 100% infill
    • 3 perimeters
    • 0.4 nozzle and 0.10mm layer height 
    • Brim enabled

Assembly Instructions

  1. Push the ball into the socket
  2. Gently screw the bolt into the threaded end of the ball
  3. Very gently, screw the bolt into the bottom of your webcam

Adjustments

Putting lateral pressure on the bolt is just asking for it to snap off in the bottom of your camera.  If you need to adjust the position of the ball, use a pair of needle nose pliers around the thin neck of the ball to put it into position without the webcam attached.  It's a pretty tight fit, and the pliers will give you the leverage you need to make the necessary adjustments. 

Tags