Logitech Pedal G923 Gas Throttle Spacer
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Logitech Throttle Pedal Spacer
- Rating
- 0 / 5
- Likes
- 21
- Downloads
- 92
- Makes
- 0
- Views
- 1,487
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Video Games
- License
- Creative Commons — Attribution — Noncommercial — NoDerivatives
Logitech Pedal G923 Gas Throttle Spacer
Gas/Throttle Pedal spacer plate to put pedal face flush (even) with brake and clutch pedal!
Hardware;
Bolts; M4 x 30mm, Qty. 2
Alternative; 8-32 x 1-1/8 Qty.2 can be used in a pinch, use with caution!!
Install;
Remove stock M4 flush head bolts holding gas pedal to backing plate. From behind, remove the single silver plastic Phillips head screw holding on the black spacer plate to the metal pedal frame. This black spacer plate is replaced by the printed Throttle Spacer Plate. Insert silver screw into new backing plate securing it to the metal pedal frame, pre-thread the hole as needed. Bolt on gas pedal through extended spacer plate using new (longer) hardware.
Notes;
Part should be printed with curved surface facing up, or with rear bolt step flat to build plate. Print in ABS or similar strong, impact resistant material for best results. While this is a bolt on component, I am not responsible for any harm or damages that may occur to users or pedal base components!
Thanks for the support and viewing!