Dragonball/ Dragonball Z Logo
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Logo of the anime series Dragonball/ Dragonball Z with LED lighting
- Rating
- 0 / 5
- Likes
- 67
- Downloads
- 321
- Makes
- 0
- Views
- 2,616
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- 2D Plates & Logos
- License
- Creative Commons — Attribution — Noncommercial — NoDerivatives
I drew the logo for the series Dragonball/ Dragonball Z and equipped it with an illustration.
The logo can be scaled. I have scaled it on the MK3 to 170% in X and Y.
The letters should be printed individually. It takes some patience, because the letters are only 0,4mm thick. There may be some misprints.
It is best to print the letters individually. I have printed them in 0.2 quality.
I used the following filaments.
yellow
orange
red
an black for the body
To diffuse the light a little and to make the LED strip less visible, I placed sandwich paper over the LED strip. Simply lay it over the body and cut it out with a sharp knife. Then insert the socket and everything stays in place. I fixed the letters with superglue. I fused the two bodies together with a soldering iron. Then I smoothed them again with a knife.
Below are a few photos of how I put it together. There you can also see a comparison when there is no sandwich paper over the LEDs.
On the back of the model are brackets for a wall mount.
You need also:
- hotglue
- soldering iron
- cable e.g. 0.25mm²
- knife
- side cutter
- sandwich paper
- LED-Strip
