Milwaukee drill mount
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
I recently found this holder :https://www.thingiverse.com/thing:882861 and found that while the idea was great, it…
- Rating
- 5 / 5
- Likes
- 249
- Downloads
- 1,016
- Makes
- 6
- Views
- 5,427
- Reviews
- 6
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
I recently found this holder :https://www.thingiverse.com/thing:882861 and found that while the idea was great, it wasn't very practical for me. I printed two of them and found they were just a bit too small for my drivers and the offset mount broke easily when it was bumped into. So I decided to make my own from scratch in Fusion 360. The flush mount design should give it better durability and make it stick out less from your bench or wall. It is just a bit over-sized, but i figure it will also work for several different drivers by other manufacturers. There is definitely no chance of the driver falling out on its own. I'm sharing two versions, the first has an opening for the handle to come out at 90 degrees to the surface you attach the mount to, and the second has the handle parallel to it.
I did not need supports for this print, however your experience may vary depending on how good your part cooling is and how nice you want it to look when its done.
Print instructions
This should print without supports. I use .28 layer height with 4 shells and 25% infill.