Upshot - Actions have Consequences

A completely original ‘3D’ board game!

Parts to Print (print at 200um linear advance for better results)

Body trunk x 1 (brim required)

Ring OR  Ring V2 with Grip x 4

Pawn 3 Pcs x 4 of different colors (support required)

Tiles 12 Pcs x 4 of different colors (brim required)

Home Line x 4 of different colors (glue stick helps) - Consists of both Homeline + Entry line

this part will give you an error when you slice it but go ahead irrespective of that. The design is intentional as two different parts with the same profile need to be printed, so I've combined them into one. the breaking of this part into two is extremely satisfying!

Throne x 1 

Top Cap x 1

Bottom Cap x 1

Case Tray Grid x 1

Pawns & Tile Case (Print in Place) - Bottom fill pattern : Concentric (gives a lovely look and feel to the case)

Small pieces (an inch at the max) of filament of the colors for pawns and tiles required.

Adding felt / foam pads to the base of the cylinder might be required.

__________________________

1 Dice required 

___________________________

The pawns might be a slight tight fit so be careful while inserting them, the reason being when you rotate the rings, the pawns of a higher tolerance were falling down by the vibrations. 

You can replace the colored tiles with white to decrease the probability of two colored tiles matching, thus making the game more difficult as mentioned.

Nomenclature of the game. 

The case to store all the pawns, extra tiles, throne and the dice! It's a Print-In-Place, no assembly required container which fits perfectly inside the ‘body trunk’ of the game!

Assembly of the Game :

                                                                       Thank You!