Spy Sender Helmet Modified Goggle Clip
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is a modified goggle clip for a Sender Spy helmet. Use with Smith goggles or as a replacement.
- Rating
- 0 / 5
- Likes
- 5
- Downloads
- 68
- Makes
- 0
- Views
- 469
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Winter Sports
- License
- Creative Commons — Attribution — Share Alike
Modified goggle clip for Spy Sender helmet (the ones at Costco). I made this because the factory clip doesn't fit over the buckle on Smith goggles. It would serve just as well as a replacement for a lost or broken clip.
Print at 100% infill with supports in the default orientation. The supports use very little material and come off easily. I used PETG filament. Layer height doesn't matter. Prints in about 1.5 hours.
The original clip has some glue on it above the screw--this needs to be replaced to avoid stressing the screw. I used gray RTV silicone and that seemed to work OK (probably any silicone is fine). This clip is a lot more rigid than the original and I don't recommend pulling it back to far. I've been holding the base with my thumbs while I slip the goggle strap in from the top. Maybe it should be a little thinner. STEP model included if you want/need to remix.
(regarding the naming: v1.4 was the first version I replaced publicly--you're not missing anything)