GoPro Box Mount Magnetic
We calculate the final price from your selected file. You review and accept it before payment.
Estimated printing price per file
€1.03 – €1.26 net (excluding VAT)
For file: GoPro Box Mount Magnetic_0.2mm_PLA_MK2S_1h1m.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €1.15 excluding VAT (range midpoint).
- Weight reported by the author
- 17 g
- Print time reported by the author
- 1.02 hr
- Source material
- PLA
- Estimate material
- PLA
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
A magnetic addon for the GoPro which comes mounted in the box who's only purpose is to showcase the camera. 1hr print!
- Rating
- 0 / 5
- Likes
- 6
- Downloads
- 22
- Makes
- 0
- Views
- 645
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Portable Devices
- License
- Creative Commons — Attribution — Share Alike
GoPro (Hero 8 and below) comes mounted in the box and that mount's only purpose is to showcase the camera and nothing else. After you take out the camera, that mount is absolutely useless and as good as waste, until now!
(I have the GoPro Hero 2018)
This 3D printable magnetic add on gives life to that mount in a very unique manner! And it takes just 1 hour to print!
Parts to Print :
GoPro Box Mount Magnetic X 1 - Layer height : 200um / .2mm (supports not required)
Neodymium Magnets required : 4 pieces - Size : 6mm(diameter) x 4mm(thickness)
Epoxy glue required (I have used Araldite epoxy) , screwdriver to remove the built in support.
The base of the mount which is made from a flexible polymer is taped to the box which you can remove. You will have to cut the base (normal cutter or a good scissor works) 1 inch (25mm) from the center of the mount on each side giving you the total width of 2 inches (50mm) as shown.
Using the epoxy glue, stick the magnets in the given slots. Wait for the glue to harden. You can add more magnets if you feel the mount cannot take the weight of it, but 4 magnets worked like a charm for me!
Remove the built in support using the screwdriver. The built in support has been added in a way which will come off easily with minimum efforts. Start sliding in the GoPro mount base in the slots as shown!
Your new GoPro magnetic mount is now ready!
I have been using this mount for the last 2 and a half years successfully!
THANK YOU!