1 / 1
Eibos Cyclopes Drier Fan Converter
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Another 80mm fan converter for Cyclopes Drier, easier to install.
- Rating
- 5 / 5
- Likes
- 31
- Downloads
- 150
- Makes
- 9
- Views
- 2,031
- Reviews
- 9
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Public Domain
Eibos Cyclopes Drier's fan is noisy. Inspired by https://www.printables.com/model/51737, I created another fan converter for Noctua 80mm fan.
Features (compared to 51737):
- Have hole for fan cable
- Better air flow (I hope so. I'm not sure)
- Higher (more space to reduce cross-sectional area)
- Larger center air way (the heater area is a rectangle, not a circle)
- Compatible with M4 screws and nuts
Requirements:
- Noctua 5V 80mm fan
- Either (fan screws x4) or (M4x12 screws x4 and nuts x4)
- Bigger stands x4 (from https://www.printables.com/model/51737)
Install instructions:
- Unscrew the four stands, open the back panel, and unscrew the original fan
- Remove original fan cable and connect with Noctua's
- The easier way is cutting the original cable and using Noctua's OmniJoin cable
- Otherwise, be sure the fan is on the other side of the back panel if your new cable is not reconnectable.
- Screw the fan onto the fan converter (align with the cable hole)
- Close the back panel (cable hole is on the side)
- Screw the fan converter to the base (through the fan blades; reuse original screws)
- Screw the bigger stands (reuse original screws)
Print instructions:
PETG, 0.15mm layer height. No support is needed.