Light panel enclosure
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Available in three sizes.
- Rating
- 0 / 5
- Likes
- 6
- Downloads
- 29
- Makes
- 0
- Views
- 203
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Photo & Video
- License
- Creative Commons — Attribution
This is an enclosure I made for turning some LED strip I had lying around into some simple light panels.
The “shade” should be printed with the broad side flat on the build plate, and is thin enough to allow light to pass through while not being too weak. It snaps onto the body without any screws or glue needed to hold it. Don't be afraid to flex things a little.
There is a hole for a “tripod screw” sized threaded insert (as available from here or here) and a hole for a panel-mount barrel jack (as available from here) on the base, so it can be reliably attached to standard equipment. Just make sure to note down the voltage.
Three sizes are included:
- “Mini” is 150x150mm
- “Medi” is 200x200mm
- “Maxi” is 250x250mm
Pick whatever size will fit your machine best.