Keyrack motorcycle, home, bicycle, car
We calculate the final price from your selected file. You review and accept it before payment.
Preliminary estimate for PETG
€1.49 – €1.82 net (excluding VAT)
For file: Models_0.25n_0.12mm_PETG_MK4IS_2h9m.bgcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €1.66 excluding VAT (range midpoint).
- Weight reported by the author
- 11 g
- Print time reported by the author
- 2.16 hr
- Source material
- PET
- Estimate material
- PETG
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
A place to hang your keys together!
- Rating
- 0 / 5
- Likes
- 9
- Downloads
- 43
- Makes
- 0
- Views
- 240
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Garage
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
When i was looking for a fitting key holder for various keychains of mine, none were eaxactly what i was looking for.
I remixed a few Printables with their shapes and designed a backboard with custom key hooks, which resulted in this upload!
This design is made with 3 hooks, but can easily be self changed since i did add the key hooks in the files, put a flat plate (3mm thick in this design) in your editor/slicer and put these key hooks in them (70mm apart from each other in this design).
I've added some extra remixes in the files from some other logo's/pictograms, just glue them in place which one you like. Tip: for smoothest result, glue the models with the printbed-side UP, so the evenly textured/smooth surface of it will face you when looking at the keyrack!
Don't make the same mistake i did by putting too few solid top layers at the keyrack, which the result is to be seen in the photo's ;)
Recommanded print settings for the backboard+hooks:
- 0.6/8mm nozzle (structural purpuse).
- 3 or more perimeters.
- 4or5 top and 3 bottom solid layers (large area's tend to slack and make the infill visible).
- 20% gyroid infill.
- 0.40mm "Draft" layer height, since this is a structural part, no need for it being nice.
- Supports: Off.
- Every other setting is the stock Prusament PETG setting in 0.6mm or 0.8mm nozzle configs.
Recommanded print settings for the models:
- 0.25mm nozzle.
- 3 perimeters.
- 3 top and 3 bottom solid layers.
- 15% gyroid infill
- 0.12mm ""Structural" layer height.
- Supports: Off.
- Every other setting is the stock Prusament PETG setting in 0.25mm nozzle config.