1 / 4
Magnetic Glue Stick Holder - 6mm x 3mm magnets — image 1
1 / 4

Magnetic Glue Stick Holder - 6mm x 3mm magnets

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Simple Glue Stick Holder suitable for 6mm x 3mm magnets fits Elmer's glue sticks

Rating
5 / 5
Likes
2
Downloads
51
Makes
3
Views
201
Reviews
2

Updated at source:

Model information

Category
Office
License
Creative Commons — Attribution — Noncommercial

Created this for my Bambu Carbon, only to realise ‘after’ printing that the sides of the printer are ‘not’ magnetic 🤣

But works very well installed with Command strips too! Was installed over 12mths ago and hasn't fallen off once.

Originally designed to fit the glue stick that comes with the Bambu, but discovered it's smaller than standard size glue sticks. Redesigned to hold the larger standard size Prittstick/Elmer's glue size stick.

 

---------------------------------------

Measurements:

  • Internal (to check if glue stick fits) - 31.5mm diameter, 47.5mm depth
  • Magnet holes - 6.5mm diameter, 3.2mm depth

Print notes:

  • PLA
  • No supports needed
  • I used 15% infill & super draft
  • Print with bottom surface of design on print bed for no supports and maximum strength

---------------------------------------

Install notes:

  • 4 x magnets (6mm x 3mm)
  • 'Tiny' amount of hot glue or superglue on base of magnet hole and around the edges
  • Place magnets
  • Clear any excess
  • Wait to cool/cure
  • Put on magnetic surface! 
  • OR if putting on a Bambu, ignore all the above and use a Command strip instead 🤣

Tags