Dropped Ceiling Cable Clamp - Large
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
For routing cables from a dropped ceiling outlet
- Rating
- 0 / 5
- Likes
- 6
- Downloads
- 47
- Makes
- 0
- Views
- 334
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Engineering
- License
- Creative Commons — Attribution — Share Alike
This is a cable clamp made to fit into the braces of a dropped ceiling. Fits up to 14mm diameter cables. Fit the cable in the clamp, then slide the large end into the brace and snap in the other end.
For best results, I'd suggest alternating the direction of the clamps and using plenty of them. Tested with PLA and they work fine so far, but use whatever you're comfortable with.
This is designed for ceiling braces that are 23-24mm wide and where the tiles don't extend beyond the brace. These are typically found in engineering spaces and labs. Feel free to try regardless and if they don't work or you need a smaller clamp, check out my other ceiling cable clamp:
https://www.printables.com/model/769260-dropped-ceiling-cable-clamp-small
Print Tips
Print on its side. Any material should do. A brim may help.
Use at your own risk, I'm not responsible for damage caused by broken clamps.
Love,
Blunt