SBS Slab Stock, Handguard, and Other QOL Things.
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
DOOL BARREL BEETHCES, also heavy af too.
- Rating
- 0 / 5
- Likes
- 27
- Downloads
- 71
- Makes
- 0
- Views
- 1,347
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor Sports
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Stock, Handguard and other parts for the SBS SLAB. Also a bunch of info to make your own, listed in random order.
-Only 2 c4 and t4 bars are required for assembly. 2 12 inch threaded rods (10-24 or 10-32) are used.
-The pins for the magwells and levers are 2 3 inch clevis pins and 2 3.5 inch pins. You cannot use the 3 inch pins in the lever or magwell. Pin I used for the 3.5 inch one that is hard to find. https://www.mcmaster.com/92735A159/
-The Stock provided is the default slab stock, but with a buttplate that is flat. Other stocks can be resized in the z to match the ones provided if desired.
-The handguard is specific to this sbs slab, but other handguards can be created based on this handguard. I used 2 of these for this handguard specifically. https://www.printables.com/model/685908-sillybutts-slab-minimal-lower-handguard-mounting-p
-The levers requires supports near the pivoting pins for clearing the threaded rods. Dont put supports anywhere else.
-The top cover requires support for the back tab and on one side of the inside ledge
-The standard magwell most likely does not fit. I used angled ones and they barely clear.
-The side plates require supports for the overhang.
-I dumped the files here of what I used for my build. Including the duplicates and not modified parts. Because finding and compiling parts for a reference is ass. They are the ones in the folders.
-There are pictures for assembling the "internals", as it is not clear in the original.
-There are dummy bar spacers for the muzzle. This prevents the pins from moving around too much. Print 2 of them and attach to the muzzles.
-The part that holds the treaded rod must spin freely on the trigger linkage. I drilled out the hole so it rotates, while a 4-40 screw holds the part on.
Some parts need 2 parts of the same thing, but mirrored.
Remixed https://www.printables.com/model/308896-slab-shroud/comments because no derivatives is stoopid.