1 / 9
SBS Slab Stock, Handguard, and Other QOL Things. — zdjęcie 1
1 / 9

SBS Slab Stock, Handguard, and Other QOL Things.

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

DOOL BARREL BEETHCES, also heavy af too.

Ocena
0 / 5
Polubienia
27
Pobrania
71
Wydruki
0
Wyświetlenia
1347
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Stock, Handguard and other parts for the SBS SLAB. Also a bunch of info to make your own, listed in random order. 

 

-Only 2 c4 and t4 bars are required for assembly. 2 12 inch threaded rods (10-24 or 10-32) are used. 

-The pins for the magwells and levers are 2 3 inch clevis pins and 2 3.5 inch pins. You cannot use the 3 inch pins in the lever or magwell.  Pin I used for the 3.5 inch one that is hard to find. https://www.mcmaster.com/92735A159/

-The Stock provided is the default slab stock, but with a buttplate that is flat. Other stocks can be resized in the z to match the ones provided if desired. 

-The handguard is specific to this sbs slab, but other handguards can be created based on this handguard.  I used 2 of these for this handguard specifically. https://www.printables.com/model/685908-sillybutts-slab-minimal-lower-handguard-mounting-p

-The levers requires supports near the pivoting pins for clearing the threaded rods. Dont put supports anywhere else. 

-The top cover requires support for the back tab and on one side of the inside ledge 

-The standard magwell most likely does not fit. I used angled ones and they barely clear. 

-The side plates require supports for the overhang. 

-I dumped the files here of what I used for my build. Including the duplicates and not modified parts. Because finding and compiling parts for a reference is ass. They are the ones in the folders. 

-There are pictures for assembling the "internals", as it is not clear in the original. 

-There are dummy bar spacers for the muzzle. This prevents the pins from moving around too much. Print 2 of them and attach to the muzzles.  

-The part that holds the treaded rod must spin freely on the trigger linkage. I drilled out the hole so it rotates, while a 4-40 screw holds the part on. 

Some parts need 2 parts of the same thing, but mirrored. 

Remixed https://www.printables.com/model/308896-slab-shroud/comments because no derivatives is stoopid.

 

Tagi