1 / 4
Multiboard Snap Mount Caliper Holder
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A snap mount fitting caliper holder remix for the Multiboard wall organizer system
- Rating
- 4.923 / 5
- Likes
- 137
- Downloads
- 1,373
- Makes
- 26
- Views
- 3,323
- Reviews
- 26
Updated at source:
Model information
- Source
- Printables
- Category
- Organizers
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
A remix of the Multiboard Push-Fit Caliper holder to directly use the official multiboard remix snap fitting. I found the push fitting to be too loose for my preferences. By using the snap fitting directly, the caliper holder is solidly locked into place on the board.
Confirmed to fit:
- NEIKO 01407A Electronic Digital Caliper (Amazon US direct link, no commission)
The following settings were used to print this is one piece.
Print orientation:
- Face-up, with critical region supports enabled.
Quality
- Layer Height: 0.2mm
- Wall printing order: Inner/Outer/Inner
Strength
- Wall Loops: 3
- Infill: 15%, Gyroid
- Top Shell: 5 layers, 1mm thickness
Speed
- Outer Wall: 180 mm/s
- Slow Down for Overhangs
Support
- Enabled
- Support Critical Regions Only