Table Clamp for 40x40mm ITEM 4040 Aluminum Extrusion
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A simple, quick-printing light-duty table clamp for securing 4040 profile to a table.
- Rating
- 0 / 5
- Likes
- 30
- Downloads
- 129
- Makes
- 0
- Views
- 921
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Engineering
- License
- Creative Commons — Attribution
A simple, quick-printing light-duty table clamp for securing 4040 aluminum extrusion to a table.
This was produced specifically for the ITEM 4040 Profile 8 geometry linked here and pictured below, but it should work for other similar 40 mm extrusion profiles with similar (~8mm-wide) T-Slot geometry.
The model prints without supports, on its side. I recommend printing it with ~7-8 perimeters, which will yield effectively 100% perimeters – infill is then irrelevant.
I provide two versions: one with a countersunk hole and one with a simple hole.

