1 / 3
Table Clamp for 40x40mm ITEM 4040 Aluminum Extrusion — zdjęcie 1
1 / 3

Table Clamp for 40x40mm ITEM 4040 Aluminum Extrusion

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A simple, quick-printing light-duty table clamp for securing 4040 profile to a table.

Ocena
0 / 5
Polubienia
30
Pobrania
129
Wydruki
0
Wyświetlenia
921
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Engineering
Licencja
Creative Commons — Attribution

A simple, quick-printing light-duty table clamp for securing 4040 aluminum extrusion to a table.

This was produced specifically for the ITEM 4040 Profile 8 geometry linked here and pictured below, but it should work for other similar 40 mm extrusion profiles with similar (~8mm-wide) T-Slot geometry.

The model prints without supports, on its side. I recommend printing it with ~7-8 perimeters, which will yield effectively 100% perimeters – infill is then irrelevant.

I provide two versions: one with a countersunk hole and one with a simple hole.

 

Tagi