Sea-Doo Ski Pylon Support
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Adds strength to the ski pylon on 2020 Sea Doo's.
- Rating
- 0 / 5
- Likes
- 12
- Downloads
- 77
- Makes
- 0
- Views
- 1,882
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor Sports
- License
- Creative Commons — Attribution — Noncommercial
Printing instructions:
4 perimeters
40% infill
No supports
Material:
Polycarbonate Blend recommended. Should work in PETG as well.
Bill of materials:
some glue (hot glue, super glue, epoxy… etc. pretty much any glue will work)
7/8" Outside Diameter PVC pipe with thick walls (thicker the better). I used grey electrical conduit.
Assembly:
Glue the keys into the slots on the bottom of the lower fittings. This keeps the keys from getting stuck in the lynq brackets.
Cut two lengths of pipe 15" long
Installation:
Extend the ski pylon and lynq attach points on your sea doo to their “in use” positions
Snap the upper fitting onto the top of the ski pylon
Snap the lower fittings into the lynq attach points
Snap in the PVC pipes, one on each side
Snap the locks onto the fittings to secure the pipes
Application:
Fit's SeaDoo 2020 GTI models including WAKE 170. May fit GTX models as well, but not tested. May fit other model years as well but untested.