Telecaster PG
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is a single piece printable (on the XL or something with similar volume) guitar body for a Squier Bullet Telecaster
- Rating
- 0 / 5
- Likes
- 8
- Downloads
- 44
- Makes
- 0
- Views
- 482
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Music
- License
- Creative Commons — Attribution — Noncommercial
I bought a beat up broken Squier Bullet Telecaster off ebay and made a new body for it. Obvious inspiration from the Gibson SG. you can mod the STL to fit a BexGears Tele Kit. the two extra middle bridge holes are the correct width for the BexGears kit I got but didn't end up using. the distance from the center hole needs and the bex holes need to be moved closer to the bridge pickup cavity, you should measure the bex kit if you are planning to do so and remove the two outer fender/squier holes.
Printed in PLA with 7 perimeters and 25% infill (honestly 10% would have been fine it's not structural). Printed on a Prusa XL.
I swapped out the standard hardware for oval philips sheet metal screws 10x1. You can readjust the size of the holes for the original screws easily.
The second STL is for the BexGears Tele Kit. I didn't slice that one but use similar settings and orientation to the Squier Bullet one.