PICO 4 powerbank holder
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This mount allows to use a powerbank XS10000 to the Pico 4 VR headset.
- Rating
- 0 / 5
- Likes
- 12
- Downloads
- 88
- Makes
- 0
- Views
- 806
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Virtual Reality
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
The XS10000 can keep the PICO4 charged without stressing the battery and has a switch to stop the charging, i tried different power banks but this one seem to allow 4 hours of play.
My suggestion is to activate it when the internal battery is around 50% of charge.
Use 2 20 to 25 mm M3 flat head or hex screws and two small washers to assemble the 2 parts.
Print the mount with the flat surface facing the plate. Also The holder must be printed with the hinges facing the plate.
Use velcro or double sided tape to fix the mount to the headset.
I printed it with this settings:
- 0.2mm layer height
- 5 mm brim
- organic supports
Grey PLA has been used.
NOTE: tighten the screws to keep the two parts with the desired angle, i used a piece of velcro to be sure that the battery pack does not fall out during movenents but the fit is tight anyway.