1 / 6
CR-10 SE Nebula Camera Side Mount
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
It's a holder for the nebula camera to go on the side of the CR-10 SE.
- Rating
- 5 / 5
- Likes
- 27
- Downloads
- 167
- Makes
- 1
- Views
- 1,290
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Creality Parts & Upgrades
- License
- Creative Commons — Attribution
It's a holder for the nebula camera to go on the side of the CR-10 SE. It also tilts up to move out of the way.
Instructions:
- Take the “nebula camera holder” and the “nebula camera holder arm” and slot them into each other. (see picture 5)
- Take a piece of filament and push it through the hole on the side. you can cut it off from both ends, or heat it up and push the end to make sure that the filament will never come out. (see picture 6)
- Put the nebula camera in the slot.
- and last but not least put the whole assembly onto the printer!
Print Settings:
Layer Height: 0.2mm
Infill: 20%
Walls: 2
Supports: Yes