MK3 MK4 Three sheet holder for Gridfinity
We calculate the final price from your selected file. You review and accept it before payment.
Preliminary estimate for PETG
€4.57 – €5.58 net (excluding VAT)
For file: MK3 MK4 Three sheet holder for Gridfinity v1_0.6n_0.35mm_PETG_MK3SMMU3_3h58m.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €5.08 excluding VAT (range midpoint).
- Weight reported by the author
- 93 g
- Print time reported by the author
- 3.96 hr
- Source material
- PET
- Estimate material
- PETG
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
Vertical holder for Prusa MK3 and MK4 steel sheets.
- Rating
- 0 / 5
- Likes
- 11
- Downloads
- 55
- Makes
- 1
- Views
- 264
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution
I love the vertical format of the original holder, and wanted to incorporate it into my gridfinity system.
My goal was to use the smallest grid section possible, which is 1x7.
I trimmed the ends of the outer blocks so it can be printed diagonally on my Prusa MK3S+ (or any of the i3 models)
It takes common 6x2mm magnets, if you want extra stability, but it works well even without them.
I printed in PETG, with a .6 nozzle and .35 layer height. 15% gyroid infill. 2 perimiters, no supports. It is just under 4 hours to print. (The magnet holes needed a little cleanup with these settings.)