1 / 5
Radiomaster Pocket - Internal mount for Ranger Micro
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Mount a Ranger Micro PCB inside the Pocket CC2500 version, to get both ELRS and CC2500 without external modules!
- Rating
- 0 / 5
- Likes
- 12
- Downloads
- 48
- Makes
- 0
- Views
- 1,603
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- RC & Robotics
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Hardware:
- For the bottom part: M2 machine screws with 6-8mm length
- For the top part I used self tapping M2.3 screws with 6mm length
Print settings:
- Use supports for the overhang
- I used PETG for the added heat resistance
Notes:
- I recommend using the external antenna for elrs and adding an additional internal one for the cc2500 (See the third image for placement of the additional antenna).
- Wire the ELRS module to the pins for the external module bay.
- Don't forget to limit the power to 100mw, to prevent overheating or add a fan.
- Use a small amount of hot glue or similar, to prevent strain from moving the antenna from pulling on the connector.
- The case can be closed afterwards without interference.
Wiring:
Connect the following pins of the module and module bay:
- VCC/VBAT
- GND
- DATA/Signal
See this image for the pin locations:
