Creality Space Pi - Air Vent Gap Spacer
We calculate the final price from your selected file. You review and accept it before payment.
Estimated printing price per file
€0.13 – €0.16 net (excluding VAT)
For file: Creality Space Pi - Air Vent Gap Spacer - 2mm_0.4n_0.25mm_ASA_MINI_8m.bgcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €0.14 excluding VAT (range midpoint).
- Weight reported by the author
- 1 g
- Print time reported by the author
- 7.8 min
- Source material
- ASA
- Estimate material
- ASA
- Estimate printer
- Bambu Lab X1 Carbon - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
Spacer to allow humidity to be vented out of the Creality Space Pi filament dryer
- Rating
- 4.982 / 5
- Likes
- 431
- Downloads
- 3,401
- Makes
- 53
- Views
- 17,416
- Reviews
- 56
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution
Creality Space Pi is a nice filament dryer. However, there is one major flaw (similar to some other dryers, like Sunlu S2) - it does not vent out the humid air. This traps humid air inside the dryer, making it hard if not impossible to actually dry a wet filament. (I found this video which shows the issue.)
This spacer creates a small gap (~2 mm) between the lid and the case, which, according to my measurements, is sufficient for continuous release of the trapped humidity. Larger vent would cause too much heat to be released, unnecessarily increasing the dryer power consumption.
The spacer is made to nicely fit at the top of case, where it keeps itself securely attached - but could be also easily removed.
Printing tips
- It should be printed from heat-resistive filament (at least PETG, but I recommend something like ASA/PC).
- I made it to be minimalist (less than 1 g of filament with 100% infill) and quick to print (8 minutes on my MINI with 0.25mm layer).
Other information
You may also be interested in other model I made for Creality Space Pi dryer: stackable trays for drying silica gel desiccants and thermometer sensor mount.